[UPDATED 2025] Free HP HPE7-A01 Exam Questions Self-Assess Preparation [Q33-Q57]

NEW QUESTION 33
With Aruba CX 6300. how do you configure ip address 10 10 10 1 for the interface in default state for interface 1/1/1?

NEW QUESTION 34
A customer just upgraded aggregation layer switches and noticed traffic dropping for 120 seconds after the aggregation layer came online again.
What is the best way to avoid having this traffic dropped given the topology below?

NEW QUESTION 35
On AOS10 Gateways, which device persona is only available when configuring a Gateway-only group’?

NEW QUESTION 36
A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802.1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages. The switch should send a warning to the helpdesk when the problem occurs. You have been asked to implement an effective solution to the problem.
What is the solution for this?

NEW QUESTION 37
Refer to the image.

Your customer is complaining of weak Wi-Fi coverage in their office. They mention that the office on the other side of the hall has much better signal.
What is the likely cause of this issue7

NEW QUESTION 38
With the Aruba CX 6200 24G switch with uplinks or 1/1/25 and 1/1/26, how do you protect client ports from forming layer-2 loops?

NEW QUESTION 39
Refer to the image.

Your customer is complaining of weak Wi-Fi coverage in their office. They mention that the office on the other side of the hall has much better signal What is the likely cause of this issue7

NEW QUESTION 40
How do you allow a new VLAN 100 between VSX pair inter-switch-link 256 for port 1/45 and 2/45?

NEW QUESTION 41
You are are doing tests in your lab and with the following equipment specifications:
* AP1 has a radio that generates a 16 dBm signal.
* AP2 has a radio that generates a 13 dBm signal.
* AP1 has an antenna with a gain of 8 dBi.
* AP2 has an antenna with a gain of 12 dBi.
* The antenna cable for AP1 has a 4 dB loss.
* The antenna cable for AP2 has a 3 dB loss.
What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for AP1?

NEW QUESTION 42
A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem What is the solution for this?

NEW QUESTION 43
A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcarriers to clients.
Which technology is the best match for this use case?

NEW QUESTION 44
With the Aruba CX 6100 48G switch with uplinks of 1/1/47 and 1/1/48. how do you automate the process of resuming the port operational state once a loop on a client port is cleared?

NEW QUESTION 45
Your customer is having connectivity issues with a newly-deployed Microbranch group The access points in this group are online in Aruba Central, but no VPN tunnels are forming.
What is the most likely cause of this issue?

NEW QUESTION 46
Your customer is interested in hearing more about how roles can help keep consistent policy enforcement in a distributed overlay fabric.
How would you explain this concept to them?

NEW QUESTION 47
What is the best practice for handling voice traffic with dynamic segmentation on AOS-CX switches?

NEW QUESTION 48
With the Aruba CX 6200 24G switch with uplinks or 1/1/25 and 1/1/26, how do you protect client ports from forming layer-2 loops?

NEW QUESTION 49
You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

NEW QUESTION 50
List the WPA 4-Way Handshake functions in the correct order.

NEW QUESTION 51
Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

NEW QUESTION 52
In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

NEW QUESTION 53
A network administrator is attempting to troubleshoot a connectivity issue between a group of users and a particular server The administrator needs to examine the packets over a period of time from their desktop; however, the administrator is not directly connected to the AOS-CX switch involved with the traffic flow.
What statements are correct regarding the ERSPAN session that needs to be established on an AOS-CX switch’? (Select two )

NEW QUESTION 54
In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

NEW QUESTION 55
You need to drop excessive broadcast traffic on an ingress port or an ArubaOS-CX switch. What is the best feature to use for this task?

NEW QUESTION 56
A customer wants to enable wired authentication across all their CX switches One of the requirements is that the switch must be able to authenticate a single computer connected through a VoIP phone.
Which feature should be enabled to support this requirement?

NEW QUESTION 57
Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central What application must the office manager use on their phone to complete this task?