[Jan-2024] 156-835 Free PDF from ActualPDF [Q34-Q48]

QUESTION 34
When running ifconfig command on an Appliance, there are interfaces shown in the list: ethl-Sync and eth2-Sync. What is the purpose of these interfaces?

QUESTION 35
What will happen in case of NAT of the traffic passing through Management network?

QUESTION 36
What is an uplink interface used for?

QUESTION 37
How many power supplies are presented on MHO-140?

QUESTION 38
What command will be used for updating fwkern.conf file on all Appliances within Security Group?

QUESTION 39
What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

QUESTION 40
What cannot be a reason for DETACHED status of Appliance when running asg monitor command?

QUESTION 41
What is the default Distribution mode?

QUESTION 42
What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI

QUESTION 43
There’s a 23800 appliance with quad NIC in slot 5. What would be the name of port 3 on this NIC?

QUESTION 44
What does the lldpctl command do?

QUESTION 45
What cannot be learned from the output of asg perf -v -p command?

QUESTION 46
What cannot be learned from the output of lldpctl?

QUESTION 47
Which licenses should be issued for the Orchestrator?

QUESTION 48
One single Appliance supports 1M concurrent connections. How many concurrent connections will support Security Group of 2 Appliances?