Grab latest NICET ITFAS-Level-1 Dumps as PDF Updated on 2025 [Q33-Q47]

Rate this post

Grab latest NICET ITFAS-Level-1 Dumps as PDF Updated on 2025

Newly Released ITFAS-Level-1 Dumps for Inspection and Testing of Fire Alarm Systems Certified

Q33. According to NFPA 72, manual fire alarm boxes shall be located within which distance of each exit doorway on each floor?

5 feet (1.5 meters)

6 feet (2.0 meters)

16 feet (5.0 meters)

33 feet (10.0 meters)

Q34. How is a lead-acid battery inspected?

By checking for damage

By checking voltage

By verifying specific gravity

By verifying the charging circuit

Q35. What is the inspection frequency of supervising station alarm system transmitters?

Monthly

Quarterly

Semiannually

Annually

Q36. A disconnection of the primary phone line shall cause which of the following events to occur?

Activation of notification appliance

Local annunciation only

Notification via secondary phone line

Supervisory condition

Q37. What is the maximum travel distance between two fire alarm boxes measured horizontally on the same floor?

30 feet (9.1 meters)

60 feet (18.3 meters)

90 feet (27 meters)

200 feet (61 meters)

Q38. Which three of the following branch circuit characteristics are required for circuit identification and accessibility of the fire alarm equipment’s primary power supply? (Choose three.)

The system circuit disconnect shall be permanently identified as “Fire Alarm.”

The system circuit disconnect shall be permanently identified at the control unit.

Where a circuit breaker is the disconnecting means, a breaker locking device shall be installed.

Where a circuit breaker is the disconnecting means, a breaker locking device shall be labeled.

Q39. When testing initiating devices, what is the maximum allowed time for the supervising station to verify receipt of the signal?

60 seconds

80 seconds

90 seconds

120 seconds

Q40. After 15 years from initial installation, all fixed-temperature, nonrestorable heat detectors shall be replaced or have how many detectors per 100 laboratories tested?

Q41. According to NFPA 72, which statement is true as it pertains to the testing of audible alarm notification appliances?

Sound pressure levels are required to be taken during initial acceptance and periodic testing.

Sound pressure levels are required to be taken during initial acceptance and reacceptance testing.

Sound pressure levels are required to be taken in hallways only during initial acceptance testing.

Sound pressure levels are required to be taken in sleeping areas only during initial acceptance testing.

Q42. Secondary power for the fire alarm primary power supply shall be tested under which load?

Half load

Maximum load

Minimum load

Supervisory load

Q43. A single open fault, in a Class A pathway, shall result in the annunciation of which of the following signals?

Trouble

Alarm

Pre-alarm

Supervisory

Q44. Notification appliances in a fire alarm system produce a distinctive evacuation signal that does which of the following?

Alternates on for 1 second, off for 1 second

Alternates on for 1 second, off for 1.5 seconds

Provides a 3-pulse temporal pattern

Provides a 4-pulse temporal pattern

Q45. Which two of the following are needed to perform a periodic test of a projected beam type smoke detector? (Choose two.)

Blocking the transmitter

Introducing smoke

Using a listed test switch

Using an optical filter

Q46. After the secondary power supply has operated the fire alarm system under quiescent load,the secondary power shall be capable of operating all alarm notification appliances for which length of time?

5 minutes

10 minutes

1 hour

24 hours

Q47. The flash rate of visible notification appliances shall be a minimum of how many flashes per second?